Audio Setup
Setting the Sound system, such as Cross over Network.
1Select the source to adjust Press the [SRC] button.
2Enter Audio Setup modePress the [VOL] knob for at least 1 second.
3Select the Audio Setup item to adjust Press the [VOL] knob.Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.
4Setup the Audio item Turn the [VOL] knob.Adjustment Item | Display | Range |
Front High Pass Filter | "HPF" | Through/40*/60*/80/100/120/ |
|
| 150/180/220* Hz |
Rear High Pass Filter | "HPR" | Through/40*/60*/80/100/120/ |
|
| 150/180/220* Hz |
Low Pass Filter | "LPF" | 50*/60/80/100*/120/ |
|
| Through Hz |
Subwoofer Phase | "PHAS" | Reverse (180°)/ Normal (0°) |
Volume offset | ||
Loudness | "LOUD" | OFF/ON |
Dual Zone System | "2ZON" | OFF/ON |
⁄
•* Function of
•Volume offset: Sets each source’s volume as a difference from the basic volume.
•Loudness: Compensates for low and high tones
during low volume. (Only the low tone is compensated for when the tuner is selected as a source.)
•Dual Zone System
Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.
-Set up the channel of sub source by <Dual Zone System Setting> (page 24).
-Select Main source by [SRC] button.
-Adjust the volume of Front channel by [VOL] knob.
-Adjust the volume of Rear channel by <Audio Control> (page 8).
-The Audio Control has no effect on sub source.
•You can use the Dual Zone System with the internal auxiliary input.
5Exit Audio Setup modePress the [VOL] knob for at least 1 second.
Speaker Setting
Press the [SRC] button. Select the "STANDBY" display.
2Enter Speaker Setting mode Press the [VOL] knob.3Select the Speaker type Turn the [VOL] knob.Each time you turn the knob, the setting alternates between the settings shown in the table below.
| Speaker type | Display | |
OFF |
| "SP OFF" |
For 5 | & 4 in. speaker | "SP 5/4" |
For 6 | & 6x9 in. speaker | "SP 6*9/6" |
For the OEM speaker | "SP OEM" | |
English 9