| External view | External view |
| ......... Number of items | ......... Number of items |
1 | 4 |
.........1 | .........2 |
2 |
|
.........2 |
|
3
.........1
2CAUTION
The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above.
1.To prevent a short circuit, remove the key from the ignition and disconnect the - battery.
2.Make the proper input and output cable connections for each unit.
3.Connect the wiring harness cables in the following order: ground, battery.
4.Connect the wiring harness connector to the unit.
5.Install the unit in your car.
6.Reconnect the - battery.
7.Press the reset button.
2CAUTION
•If the fuse blows, first make sure that the cables have not caused a short circuit, then replace the old fuse with one with the same rating.
•Do not let unconnected cables or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits, also do not remove the caps on the ends of the unconnected cables or the terminals.
•After the unit is installed, check whether the brake lamps, indicators, wipers, etc. on the car are working properly.
•Insulate unconnected cables with vinyl tape or other similar material.
•Some disc changers need conversion cables for connection. See the section on "Safety Precautions" for details.
•If the console has a lid, make sure to install the unit so that the faceplate does not hit the lid when closing and opening.
— 9 —