adjusting the height of the tools
Please referto page 9 on how to assemble the mixer.
whisk, stainless steel K beater,stirring tool
For best performance the whisk, K beater and stirring tool should be
almost touching the bottom of the bowl . If necessary adjust the height
using the spanner provided.
Here’show:
1 Unplug the appliance.
2 Raise the mixer head and insert the whisk, beater or stirring tool.
3 Lower the mixer head. If the clearance needs to be adjusted, raise the
mixer head and removethe tool.
4 Using the spanner provided loosen the nut sufficiently to allow
adjustment of the shaft . Tolower the tool closer to the bottom of the
bowl, turn the shaft anti-clockwise. Toraise the tool away from the bottom
of the bowl turn the shaft clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the mixer head. (Check its position see
points above).
7 Repeat the above steps as necessary until the tool is set correctly. Once
this is acheived tighten the nut securely.
high temperature flexible beater -this tool should just touch the
bottom of the bowl.
dough hook - this tool is set at the factory and should requireno
adjustment.
to fit and use your splashguardassembly
The splashguardassembly consists of 2 pieces: the heat shield and the
splashguard.
The heat shield must be fitted during cooking operations
otherwise the mixer will not operate and error code E:03 will
be displayed. The heat shield is to protect the mixer head from steam
producedduring the cooking process.
If necessary both the heat shield and the splashguardcan be fitted to retain
ingredientsin the bowl e.g. when mixing light ingredients such as flour and
icing sugar,or when cooking ingredients where moisture needs to be
retainedin the bowl. The splashguard should not be fitted to the bowl
unless used in conjunction with the heat shield.
1 Raise the mixer head until it locks.
2 Push the heat shield upwards onto the underside of the mixer head until
fully located. The heat shield must never be used withoutthe rubber seal
correctlyfitted.
3 Fit the bowl onto the base.
4 Lower the mixer head.
5 Rest the splashguard on the bowl rim and then slide forward until fully
located .
●During mixing, ingredientscan be added directly to the bowl via the feed
chute.
6 To remove the splashguard simply slide it away from the appliance.
7 To remove the heat shield, raise the mixer head until it locks. Remove the
tool, then pull the heat shield downwardsfrom the underside of the mixer
head.
Note: Only fit or removethe splashguard when the mixer head is in the
locked position.
8