cleaning and service
care and cleaning
●Always switch offand unplug before cleaning.
●A little greasemay appear at outlet when you first use
it. This is normal - just wipe it off.
●The metal surfaces of the temperaturesensors may show signs of wear
during normal use. this does not affectthe performance of the product.
●Do not leave the high temperatureflexible beater fitted to the mixer
when not in use.
appliance, outlet covers ●Wipe with a damp cloth, then dry.
●Never use abrasives or immerse in water.
high temperatureflexible beater ●Always remove the flexible wipers after use for cleaning and
storage: Firmly pull and twist each wiper until it slides offthe
stainless steel beater arm.
●Toclean the stainless steel beater arm simply remove the flexible wipers
and wash by hand in hot soapy water and dry thoroughly.
The flexible wipers should be cleaned immediately after use by
hand in hot soapy water.Use the cleaning brush supplied to clean
INSIDE each wiper.Rinse the flexible wipers under hot running
tap water and dry thoroughly.
●Torefit the flexible wipers, lubricate the stainless steel beater arms with
a small amount of freshcooking oil. Slide the flexible wipers onto the
stainless steel arm. Ensureeach wiper covers the full length of the arm
and is past the tip at the end. Repeat the processfor the second wiper.
Note: the tool should only be used with both wipers fitted.
bowl, tools, splashguard ●Washby hand, then dry thoroughly or wash in the dishwasher.
●Never use a wirebrush, steel wool or bleach to clean your
stainless steel bowl. Use vinegar or a suitable descaler to removelimescale.
●If food sticks or burns on the inside of the bowl, removeas much as possible
using the spatula provided.Fill the bowl with warm soapy water and allow to
soak. Remove any stubborn deposits using a nylon brush.
●Any discolouration of the bowl will not affectits performance.
drain hole ●Ensurethis area is free from food. If necessary use a pipe cleaner
or cotton bud to clean.
temperaturesensors ●W ipe with a damp cloth then dry thoroughly.Never use abrasives or
sharp instruments to clean the sensors.
service and customer care
●If the cordis damaged it must, for safety reasons, be replaced
by KENWOOD or an authorised KENWOOD repairer.
UK If you need help with:
●using your machine
●servicing or repairs(in or out of guarantee)
콯call KENWOOD Customer Careon 023 92392333.
Haveyour modelnumber ready - it’son the underside of the mixer.
●sparesand attachments
콯call 0870 2413653.
other countries ●Contact the shop whereyou bought your machine.
●Designed and engineeredby Kenwood in the UK.
●Made in China.
16