Assembling Bowl and Attachments Cont...
To fit attachments to the beater socket, raise the mixer head. Gently slide the attachment into the outlet turning slowly in the direction shown in the diagram, until a stop is reached.
Press firmly upwards until the attachment clicks into position. To remove the attachment turn clockwise until it is free to withdraw.
Note
The 'K' beater and whisk were correctly set in the factory and should not need further adjustment. If for any reason adjustment becomes necessary proceed as follows:
1.Disconnect mixer from mains supply.
2.Raise the head and insert beater/whisk attachment to be adjusted.
3.Hold the attachment and slacken nut with a suitable spanner (C).
4.Lower the head and rotate the attachment up or down the shaft (D). For best results the beater/whisk should be as close to the base of the bowl as possible.
5.Raise the head and holding the attachment tighten the nut.
Hint
If when the machine is run, the 'K' beater knocks the bowl, then adjustment is too low.
To remove the slow speed outlet cover, pull the locking catch to the side and pull off the cover.
Remove the juice extractor outlet cover by either pressing down and lifting free, or simply by lifting free. If a plastic plug is fitted, unscrew this before fitting the attachment.
Remove the high speed outlet cover by lifting free.
