NOTE

Pressing the TI button whilst in the MW/LW band automatically switches reception to the FM band. However, the MW/LW band is not returned to when the TI button is pressed again.

Switching to a Different Traffic Information Station:

Use the 4 / ¢ buttons to make an auto seek of the TI stations in a certain band.

NOTE

•When you are listening to a tape or disc, you cannot change to another TI station.

•When the auto TP seek function is turned on and reception starts to weaken, the tuner automatically seeks traffic information stations with better reception.

•If you are tuned to a station that is not a traffic information station itself but which provides EON services, you can still have traffic information received.

•Holding the TI button down for one second or more when the TI function is on in the disc control mode results in a change to the frequency display of the traffic information station for five seconds.

Auto TP Seek Function

When the TI function is on and poor reception conditions are experienced when listening to a traffic information station, another traffic information station with better reception will be searched for automatically. This function is on, when unit is first powered on.

Turning Auto TP Seek Function On/Off:

1Hold down the MENU button for one second or more. "MENU" is displayed and the menu mode is turned on.

2Press the ¢ button repeatedly until the Auto TP Seek function appears in the display.

Press the 4 button to search in the other direction.

The function setting is indicated by "ATPS ON" or "ATPS OFF" in the display, indicating that the function is on or off, respectively.

3Switching settings

Press either the AM button or FM button. The display and setting will change.

If the traffic information station you are tuned to experiences poor reception, this function automatically seeks another TP station.

4Press the MENU button to end the menu mode.

Presetting Volume for Traffic Information/News

Preset the volume level to be used for traffic information and news broadcasts.

1Tune into the station for which you want to set the volume.

2Adjust the volume to the desired level.

3Hold down the TI VOL ADJ button for two seconds or more. The volume level blinks once in the display to indicate that the data has been stored.

Future traffic information/news broadcasts are heard at the preset level.

NOTE

•The volume cannot be lowered by this function during tuner reception. The volume is only set when it is louder than the listening volume of the tuner.

•You can arrange only to listen to traffic information or news bulletins with at preset volume with the volume set at minimum.

— 13 —