Recording

KR-897/KR-797 (En)

When recording sound with a recorder component of KENWOOD, synchro recording is possible by setting the INPUT SELECTOR to select TAPE1 or MD according to the connected component.

18

Preparation

÷Switch the TAPE1 display to MD or VIDEO1 with the following operation.

1Select TAPE1 with the INPUT SELECTOR.

2Press and hold the AUTO key for more than 2 seconds.

Each press switches the display.

1 TAPE1

 

2 MD

 

3 VIDEO1

 

 

To record a music source

1Select the source to be recorded.

INPUT SELECTOR

Select an input source other than TAPE 1.

2Put the cassette deck in record-pause mode.

3Play the source and start recording.

The input sources are switched in the following order:

1TUNER (frequency display)

2PHONO

3TAPE1 (MD or VIDEO1)

4CD

5VIDEO2

÷The VIDEO1 display can be switched to the display of other input by using the procedure described in “Preparation” above.

÷For the synchro recording with a cassette deck and/or MD recorder, refer to the respective instruction manuals..

÷It is not possible the VIDEO1 or MD input to TAPE1 because all of these components should use the same INPUT SELECTOR position.

Copying tape (Tape dubbing TAPE 2 = TAPE 1)

1 Press the TAPE 2 MONITOR key.

Lights

 

 

 

TUNING

TAPE2

 

 

BAND DISPLAY

MONITOR

TAPE 2

C D

 

 

2Select a source other than TAPE 1.

INPUT SELECTOR

3Play cassette deck 2 and start recording on cassette deck 1.

÷For copying a tape using a double cassette deck, read the instruction manual of the double cassette deck.

Copying tape (Tape dubbing TAPE 1 = TAPE 2)

1Select TAPE 1 with the INPUT SELECTOR control of the main unit.

2Play the cassette deck connected to the TAPE 1 jacks and start recording of the cassette deck connected to the TAPE 2 jacks.

Regarding TAPE 2 MONITOR

A cassette deck or graphic equalizer can be connected to this unit’s TAPE 2 MONITOR terminals. If you connect a graphic equalizer, turn the TAPE 2 MONITOR key ON. If you connect a 3-head cassette deck, you can monitor the source sound, or the sound being recorded, while recording. Pressing the TAPE 2 MONITOR key lets you compare the recorded sound and the source sound. Refer to the operating manual for the component you connected for further details.