Kenwood KR-797, KR-897 Approximate operating range, Remote control key correspondence table (For KENWOOD component control mode), 1, ¡, 1Switch ON the power of the main unit

Operation procedure

KR-897/KR-797 (En)

13

1Switch ON the power of the main unit.

2Select the component to be remote controlled with one of the controlled component selection keys.

3Refer to the remote control key correspondence table below and press the key for the desired operation.

÷Pressing the POWER key of the remote control unit while the STANDBY indicator is lit turns the power ON. Press the desired key after the power has been turned ON.

÷When two operation keys of the remote control unit are pressed successively, press each key securely reserving an interval of more than 1 second for each press.

Remote control key correspondence table (For KENWOOD component control mode)

2Controlled component									TAPE1
			selection key		TUNER	CD		TAPE1	*1
3Operation key									(When used with a MD)
4			¢		P.CALL keys	4 , ¢			4 , ¢
			P.CALL	Recalls preset stations.		(Skip key)			(Skip key)
					AUTO key
			7			7	7		7
				Press to select the auto
						(Stop key)		(Stop key)	(Stop key)
			AUTO	tuning mode.
		DISK SKIP				DISC SKIP key		A/B key	+100
	A/B +100					Press to select the disc to	Press TAPE A or B
						be played.
			6		BAND key	6	6		6
				Press to switch the broad-
			BAND			(Play/pause key)	(Forward play key)		(Play key)
				cast band.

1, ¡

1	¡	(Tuning keys)	1 , ¡	1 , ¡	1 , ¡
		Press to tune broadcast	(Search key)	(Search key)	(Search key)
		stations.
	2			™
				(Reverse play key)

Approximate operating range

Remote sensor

�

6m

÷*1: No remote control key is marked MD, but the TAPE1 key can be used to control a MD player by switching the display of the main unit from TAPE1

to MD. $

Notes

30° 30°

Model: RC-R0505

Infrared ray system

1. The supplied batteries are intended for use in operation checks. Therefore, their lives may be shorter than ordinary batteries.

2. When the remote-controllable distance gets shorter than before, replace both batteries with new ones.

3. Malfunction may occur if direct sunlight or the light of a high-frequency lighting fluorescent lamp enters the remote control light sensor. In such a case, change the system installation position to prevent the malfunction.