English
KENWOOD disc changer control input
NOTE
To connect the Disc changer, consult your Disc changer manual.
Rear left output (White) | Front left output (White) |
|
|
| Fuse (10A) | |
|
| Wiring harness | |
|
| (Accessory1) | |
If no connections are made, do not let the wire come out from the tab. | |||
Connect either to the power control terminal |
|
| |
when using the optional power amplifier, or to | P.CONT | Power control/Motor antenna | |
the antenna control terminal in the vehicle. | |||
| |||
| ANT. | control wire (Blue/White) | |
| CONT. |
| |
FM/AM antenna input
Front right output (Red)
Rear right output (Red)
White/Black
| To front left |
FRONT • L | speaker |
| White |
Ignition key switch
Car fuse box (Main fuse)
+ | – |
|
Battery
ACC
Ignition wire (Red)
Battery wire (Yellow)
Car fuse box
Ground wire (Black) · (To car chassis)
2CAUTION
Gray/Black
| To front right |
FRONT • R | speaker |
Gray |
|
Green/Black | To rear left |
| |
REAR • L | speaker |
Green |
|
Purple/Black |
|
| To rear right |
REAR • R | speaker |
Purple |
|
2WARNING
If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box.
When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal.
— 18 —