English
— 36 —— 36 —
8 mm
MAX.
ø5mm ø5mm
8mm
MAX.

Installing in Japanese-Made Cars

T: Toyota cars
N: Nissan cars
T
N
N
TT/N
Accessory3...for Nissan car
Accessory4...for Toyota car
During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
1Refer to the section <Removing the hard rubber frame> (page
37) and then remove the hard rubber frame.
2Align the holes in the unit (two locations on each side) with
the vehicle mounting bracket and secure the unit with the
accessory screws.
34

Installation

Screwing the Faceplate on the Unit

If you want to fasten the faceplate to the main unit so that it
does not fall off.
1Refer to the section <Removing the hard rubber frame> (page
37) and then remove the hard rubber frame.
2Drop open the faceplate by pressing the Release button. Never insert the screws in any other screw hole than the one specified.
If you screw them in another hole, it will contact and may cause
damage to the mechanical parts inside the unit.
4Tighten the screw (ø2 × 4 mm) (Accessory 6) in the hole
shown on the diagram.
Accessory7
5Tighten the screws (ø2 ×6 mm) (Accessory 7) in the holes
shown on the diagram.
Accessory6
3Tighten the screw (ø2.6 × 12 mm) (Accessory 5) in the hole
shown on the diagram.
Accessory5
KRC-766(M)_U.S_r2 02.11.11 7:51 PM Page 36