Recording

Recording mode setting in digital audio source recording

(main unit only)

When recording a multi-channel digital audio source, it is recommended to set up the recording mode properly to convert the digital input into the 2-channel analog output. Usually use the "A-REC" (Auto record) mode.

However, some discs often produce sound skipping. The "M-REC" (Manual record) mode should be used with such a disc.

®Start playback, then start recording.

•If the audio reproduction stops in the middle due to change in the input signals, etc., press [AUTO/MONO].

Recording audio (analog sources)

AUTO/MONO INPUT SELECTOR

œUse [INPUT SELECTOR] to select the source (CD/ DVD, DVD/6CH or VIDEO2) you want to record.

∑Set the MD or TAPE recorder to record.

éPress and hold [AUTO/MONO] for more than 2 seconds to select a recording mode during digital input.

Recording mode

Display

Operation

Recording mode off

---

The digital input record mode is switched off.

 

 

The digital input signals (DTS, Dolby Digital

Auto record mode

"A-REC"

or PCM) are identified automatically and

converted into stereo signals that are ready

 

 

 

 

for recording.

 

 

The input signal type at the moment this

Manual record mode

"M-REC"

mode is selected is held throughout this

 

 

mode.

•When the "M-REC" mode is selected, the digital input signal is converted to stereo signals (down-mix). But once the digital signal is changed to other signal, no signal is output.

•When the "A-REC" mode is selected, the digital input signal is converted to stereo signals even if the digital signal is changed.

•When the digital mode changes during recording in the "A-REC" mode, the audio input source may be interrupted momentarily.

For "A-REC" mode:

For "M-REC" mode:

INPUT SELECTOR

œUse [INPUT SELECTOR] to select the source (other than "MD/TAPE") you want to record.

∑Set the MD or TAPE recorder to record.

éStart playback, then start recording.

Recording video

INPUT SELECTOR

œUse [INPUT SELECTOR] to select the video source (other than "VIDEO1") you want to record.

∑Set the video deck connected to VIDEO 1 to record.

•Select the REC MODE to record a digital input source. See <Recording mode setting in digital audio source recording>.

éStart playback, then start recording.

•Recording may not be normal for some video software. This is due to the copy guard condition.

English 31