Chapter One : Connecting Your Devices

Connecting Your Cable TV or Satellite Tuner, continued

Connections

Do not plug in the receiver or devices to AC power until you have connected all your devices.

This section focuses on the connections from your cable or satellite tuner to the KRF-X9995D. Please refer to your tuner’s instructions for more detail about its connection jacks and capabilities.

The instructions in this section show one of several possible variations on connecting your tuner. For further assistance on optional configurations, contact your cable or satellite provider.

To Connect a Cable TV Tuner with a Composite (RCA) Video Output:

1.Review the information under “Before You Begin” on page 1. It contains important notes about the types of video connections you can make.

2.Connect the audio and video cables from the cable tuner’s Audio and Video OUT jacks to the receiver’s VIDEO2, VIDEO3, or VIDEO4 PLAY IN jacks as shown to the left.

When the component video cables are connected, the audio and video cables of the cable TV tuner should be connected to the VIDEO3 jacks of the receiver.

3.If your cable TV tuner and TV have the COMPONENT VIDEO jacks, you can also connect them as shown on the left.

4.Go to “Noting Your Devices” on page 3 and note which jack you used to connect your tuner. In addition, note the brand name and model number of the tuner.

To Connect a Cable TV Tuner without a Composite (RCA) Video Output:

1.Connect the audio cables from the cable tuner’s Audio Out jacks to the receiver’s VIDEO2, VIDEO3, or VIDEO4 PLAY IN jacks as shown to the left.

2.Leave the cable tuner’s video out (RF jack) connected directly to your VCR or TV (wherever you already have it connected).

3.Go to “Noting Your Devices” on page 3 and note which jack you used to connect your tuner. In addition, note the brand name and model number of the tuner.

To Connect a Satellite Tuner:

1.Review the information under “Before You Begin” on page 1. It contains important notes about the types of video connections you can make.

2.If your satellite tuner has a digital output jack, connect a digital (optical or coaxial) cable between the satellite tuner’s digital output jack and the receiver’s VIDEO2, VIDEO3 or VIDEO4 digital input jack as shown in the figure on the left.

The illustration shows two digital connections, one for coaxial connection and one for optical connection. Your satellite tuner supports one or the other of these con- nection methods—do not connect both.

3.Connect the audio and video cables from the satellite tuner’s Audio and Video out jacks to the receiver’s VIDEO2, VIDEO3, or VIDEO4 PLAY IN jacks as shown

to the left.

13

Note that the jack sets are linked, even though they are

 

not adjacent. You must connect all of the cables from

 

your satellite tuner to a linked jack set. For example, if

 

you connect the analog cables to VIDEO2 and the digi-

 

tal optical cable to VIDEO3, your satellite tuner will

 

not work correctly.

 

When the component video cables are connected, the

 

audio and video cables of the satellite tuner should be

 

connected to the VIDEO3 jacks of the receiver.

 

4.If your satellite tuner and TV have the COMPONENT VIDEO jacks, you can also connect them as shown on the left.

5.Go to “Noting Your Devices” on page 3 and note which jack you used to connect your tuner. In addition, note the brand name and model number of the tuner.

When playing Dolby Digital or DTS-encoded software in multichannel configuration, the connected audio signal should be the digital signal.