Kenwood MAJOR KM040, CHEF KM030 manual troubleshooting, to fit and use your splashguard, problem

Models: CHEF KM030 MAJOR KM040

1 12
Download 12 pages 17.01 Kb
Page 6
Image 6
troubleshooting

KENWOOD CHEF AND MAJOR KM030 – KM040 series

troubleshooting

problem

The whisk or K-beater knocks against the bottom of the bowl or isn’t reaching the ingredients in the bottom of the bowl.

solution Adjust the height. Here’s how:

1Unplug.

2Raise the mixer head and insert the whisk or beater.

3Hold it, then loosen the nut

4Lower the mixer head.

5Adjust the height by turning the shaft. Ideally the whisk/K-beater should be almost touching the bottom of the bowl

6Raise the head, hold the whisk/K-beater and tighten the nut.

problem

The mixer stops during operation.

solution Your mixer is fitted with an overload protection device and will stop if overloaded to protect the machine. If this happens, unplug the mixer. Remove some of the ingredients to reduce the load, and allow the mixer to stand for a few minutes. Plug in and press the start/stop button. If the mixer does not restart immediately allow to stand for additional time.

If for any reason power to the mixer is interrupted and the machine stops working, switch off by pressing the on/off button, wait a few seconds and then switch on again. The mixer should resume operating straight away.

to fit and use your splashguard

1Raise the mixer head until it locks.

2Fit the bowl onto the base.

3 Push the splashguard onto the underside of the mixer head until fully located. The hinged section should be positioned as shown.

4Insert required tool.

5Lower the mixer head.

During mixing, ingredients can be added directly to the bowl via the

hinged section of the splashguard .

You do not need to remove the splashguard to change tools.

CHEF

1

min

P

3

4

2

1

n mi

P

5

Page 6
Image 6
Kenwood MAJOR KM040, CHEF KM030 manual troubleshooting, to fit and use your splashguard, problem