TH-K2AT/K2E/K2ET

DISASSEMBLY FOR REPAIR

4.Packing (G53-1572-02) TX/BUSY lamp installation procedure

(1)To assure waterproofing, install the packing in the chassis groove as shown in Fig. 5. (z)

(2)Install the packing TX/BUSY lamp section on the chassis. (x)

zOK

Packing

Chassis

NG

Packing

x

 

 

 

Chassis

6.Cautions for installing the chassis on the case assembly

(1)Verify that the packing (G53-1572-02) TX/BUSY lamp section is has been past through the hole in the illumination guide section on the top of the case assembly. (Fig. 7)

PTT

LOW

LAMPThepacking TX/BUSY lamp section is has

been past through the hole in the illumination guide section on the top of the case assembly.

Fig. 7

(2)Align the speaker lead as shown fig.8. Do not place the leads over the key top section, LCD section or SP/MIC/DC IN cap section.

Fig. 5

5.Packing (G53-1572-02) bottom installation procedure

(1)Before installing the numeric key PCB (TX-RX unit B/3) on the chassis, push three parts of the packing to contact tightly with the chassis as shown in Fig. 6. If the packing is not in contact with the chassis, there may be a gap between the transceiver bottom case assembly and the battery, and water may enter through the gap.

OK

NG

Push three parts of the packing to

Clearance NG

contact tightly with the chassis.

 

Fig. 6

Do not fix this part of the key top to the rib of the case assembly.

Fig. 8

7.Cautions for installing the key top on the case assembly

(1)Install the key top keypad section and the power switch section on the rib of the case assembly.

(2)Do not fix the part between the key top keypad section and the power switch section to the rib of the case assembly, but install it as shown in Fig. 8.

5