■Temporary Delete
If a key is programmed with the Temporary Delete or Scan + Temporary Delete function, you can temporarily remove specific channels from the scanning sequence during Scan. When Scan stops at a channel, you can remove that channel from the scanning sequence by pressing and holding the key programmed as Temporary Delete or Scan + Temporary Delete for 1 second.
•You cannot delete the Priority channel, if one has been set up.
•You cannot delete a channel if there will be less than 2 channels available for scanning remaining.
•To add the channel back into the Scan list, simply exit Scan mode or switch the transceiver OFF and then ON again.
■Revert Channel
During Scan, pressing the PTT switch to transmit will cause the transceiver to select the revert channel. Your dealer can program the revert channel using one of the following methods:
•Selected: The last channel selected is assigned as the new revert channel.
•Selected + Talkback: If the channel has been changed during Scan, the newly selected channel is assigned as the new revert channel. However, the transceiver also transmits on the channel where Scan is currently paused.
•Priority: If your dealer has programmed a Priority channel, it is the revert channel.
•Priority + Talkback: If your dealer has programmed a Priority channel, it is the revert channel. However, the transceiver also transmits on the channel where Scan is currently paused.
14
