51
11 MEMORY FEATURES
■Split-Frequency Channels
1Press [A/B / M/V] to select VFO A or VFO B.
•“tA” or “tB” appears to show which VFO
is selected.
2Select the frequency, mode, etc. to be stored.
•This frequency and mode will be used for
transmitting.
3Press [A/B / M/V] to select the other VFO.
4Select the reception frequency and mode.
5Press [A=B/ SPLIT] (1 s).
•“ ” appears.
6Press [QMI/ M.IN] (1 s) to enter Memory Scroll
mode.
•To exit Memory Scroll mode and abort the
storage process, press [MTR/ CLR].
7Turn the MULTI control, or press Mic [UP]/
[DWN] to select a memory channel.
•You can also select a channel by entering a
2-digit number, such as 12, using the
numeric keys. Press [1], [2] for example.
8Press [QMI/ M.IN] to store the data.
•The previous data stored in the channel is
overwritten.
Note:
When subtone frequencies differ between TX and RX
while performing memory-VFO split operation, the subtone
frequency for TX will be stored in the memory channel.
MEMORY RECALL AND SCROLL
There are 2 modes which allow you to retrieve
frequencies and associated data that you stored in a
memory channel: Memory Recall and Memory Scroll.
Memory Recall:
In this mode, the transceiver receives and transmits
using a frequency that you retrieve. You can
temporarily change the frequency and associated
data without overwriting the contents of the memory
channel when Menu No. 07 is ON (default is OFF).
Memory Scroll:
Use this mode to check the contents of the memory
channels without changing the current reception
frequency. In this mode, frequencies you retrieve are
not used for receiving and transmitting.
■Memory Recall
1Press [A/B / M/V] (1 s) to enter Memory Recall
mode.
•The memory channel that was last selected
appears.
2Turn the MULTI control, or press Mic [UP]/
[DWN] to select a memory channel.
•Continuously holding down Mic [UP]/
[DWN] steps the transceiver through the
memory channels until the key is released.
•Memory channels which contain no data are
skipped.
•You cannot change memory channels while
transmitting.
3To exit Memory Recall mode, press
[A/B / M/V] (1 s).
Note:
If Menu No. 07 is selected “on”, the frequency of the split-
memory channel can be changed while using the TF-SET
function.