Connecting Wires to Terminals
USB connector | • Do not remove the cap when you do not use the USB | |||||
|
|
|
|
|
| cable. The connector will cause the unit to malfunction if |
|
|
|
|
| To USB device | it gets in touch with any metallic part of the vehicle. |
|
|
|
|
| ||
|
|
|
|
|
|
|
Front left output (White)
Front right output (Red)
Sub Woofer right output (Red)
Rear left output (White) Rear right output (Red)
SUB WOOFER
Sub Woofer left output (White)
FM/AM antenna input
To connect these leads, refer to the relevant instruction manuals.
To Kenwood disc changer/ External optional accessory
Fuse (10A)
If no connections are made, do not let the wire come out from the tab. | Wiring harness |
(Accessory1) |
When using the optional power amplifier, connect to its power control terminal.
| P.CONT |
Depending on what antenna you are using, |
|
connect either to the control terminal of the |
|
motor antenna, or to the power terminal for the | ANT. |
booster amplifier of the | CONT |
| |
Connect to the terminal that is grounded |
|
when either the telephone rings or during | MUTE |
conversation. |
|
To connect the Kenwood navigation |
|
system, consult your navigation manual. |
|
To car light control switch
|
| ILLUM |
|
| White/Black |
To front left speaker | White | |
|
| Gray/Black |
To front right speaker | Gray | |
|
| |
|
| Green/Black |
To rear left speaker | Green | |
|
| |
|
| Purple/Black |
To rear right speaker | Purple | |
Ignition key switch | Car fuse box | |
|
| ACC |
Car fuse box |
|
|
(Main fuse) |
|
|
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)
Battery +
36 English
Ground wire (Black) - (To car chassis)
–