Connecting Wires to Terminals
USB connector
To USB device
Rear left output (White)
Rear right output (Red)
•Do not remove the cap when you do not use the USB cable. The connector will cause the unit to malfunction if it gets in touch with any metallic part of the vehicle.
Front right output (Red)
FRONT | Front left output (White) |
|
FM/AM antenna input
To connect these leads, refer to the relevant instruction manuals.
To Kenwood disc changer/ External optional accessory
Fuse (10A)
If no connections are made, do not let the wire come out from the tab. | Wiring harness |
(Accessory1) |
When using the optional power amplifier, connect to its power control terminal.
Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the
Connect to the terminal that is grounded when either the telephone rings or during conversation.
To connect the Kenwood navigation system, consult your navigation manual.
To car light control switch
To front left speaker
To front right speaker
P.CONT
ANT.
CONT
MUTE
ILLUM
White/Black
White
Gray/Black
Gray
Green/Black
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
FRONT L
FRONT R
To rear left speaker | Green | REAR L | |
|
| ||
|
|
| |
|
| Purple/Black |
|
To rear right speaker | Purple | REAR R | |
|
| ||
|
|
| |
Ignition key switch | Car fuse box |
| |
|
| ACC | Ignition wire (Red) |
Car fuse box |
|
| Battery wire (Yellow) |
|
|
| |
(Main fuse) |
|
|
|
|
| Ground wire (Black) - (To car chassis) | |
Battery +
–
English 37