16Operation of remote control unit

XD-SERIES (En)

Loading batteries
1 Remove the cover.2 Insert batteries.3 Close the cover.

2

1

section

÷ Insert two R6 (“AA”-size) batteries following the polarity indications.

Operation

Preparation

Plug the power cord into the mains power outlet and

press the on/standby ( POWER) key of the remote control unit to turn power ON. After the power has been turned ON, press the desired key.

Toturnpoweroff,presstheon/standby( POWER) key again.

The power mode enters the STANDBY mode in which the “STANDBY” indicator lights up. (The “TIMER” indicator also lights in this mode if a timer program has been activated.)

÷When pressing more than one remote control keys successively, press the keys securely by leaving an interval of 1 second or more between keys.

Remote sensor Operating range

(approx.)

6m

30˚ 30˚

1.The provided batteries are intended for use in operation checking, and their service life may be short. Notes 2.When the remote controllable distance becomes short, replace both of the batteries with new ones.

3.If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.

CHANNEL SPACE setting

(Except for the U.S.A., Canada, U.K., Europe, Australia and Russia)

The space between radio channels has been set to the one that prevails in the area to which the system is shipped. However, if the current channel space setting does not match the setting in the area where the system is to be used, for instance when you move from area 1 or area 2 shown in the following table or vice versa, proper reception of AM/FM (MW/FM) broadcasts cannot be expected. In this case, change the channel space setting in accordance with your area by referring to the following table.

 

Area

CHANNEL

 

SPACE freq.

 

 

 

 

 

 

 

1

USA, Canada and South

FM

:

100 kHz

 

American countries

AM

:

10 kHz

2

Other countries

FM

:

50 kHz

 

 

AM :

9 kHz

 

 

 

 

 

1Select the TUNER input.

2While holding the SELECT key depressed, turn the SOUND CONTROL jog dial to select the

system mode.

ND CONT

R

 

U

O

O

 

S

 

L

SELECT

1 “FM100/AM10 kHz” STEP, 2 “FM 50 /AM 9 kHz” STEP,

F M 1 0 0 / A M 1 0

F M 5 0 / A M 9

÷The “AM” display is variable depending on the model (country or area), and “MW” may be displayed in some areas.

3Establish the selection.

ENTER