System connection 7

XD SERIES (En/E2)

Connection of parallel cord

÷When connecting the parallel cord, insert plug straight into the connector until it clicks to look them securely.

÷When connecting the parallel cord, the wire while line should come to the left side end.

÷When disconnecting the parallel cord, push in the two sides of the plug and pull it straight out.

4

Caution regarding placement(Front View)

The external view is variable depending on the model and marketing destination type.

Please install as shown below, as otherwise fire may be caused by overheat- ing.

From the top to the bottom

Amplifier

:A-H5

Tuner/Equalizer :C-H6 or C-H5

CD player

:DP-H5 or DP-MH5

Cassette deck

:X-H5

− +

Speaker (left)Main unit

1

2

3

4

Twist

Speaker Unit

1

2

3

4

Twist

To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projec- tions) equal to, or greater than, shown below.

top panel:

50 cm

rear panel:

10 cm

left and right panels: 10 cm

Notes

1.Be sure to insert all connection cords securely. If their connec- tions are imperfect, the sound may not be produced or noise may interfere.

2.Before plugging or unplugging a connection cord, be sure to unplug the power cord from the wall AC outlet. If connec- tion cords are plugged or un- plugged with the power cord left plugged in, malfunction or damage may result.

3.When arranging the system units in a vertical, stacked con- figuration, observe the stack- ing order indicated in the sys- tem connection diagram.

4.In case an associated system component is connected, also read the instruction manual of the component.

5.Align the front panels of all sets flush.

6.Never short-circuit the + and – speaker cords.

7.If the left and right speaker con- nections or the + and – polarity are inverted, the sound will be unnatural with unclear position- ing of musical instruments, etc. Be sure to connect them with- out mistake.

section Preparation

section Application

sections Knowledge