72
Preparation section
Application section
Knowledge sections
In case of difficulty
XD SERIES (En/E2)
Amplifier/Speaker unitSymptom | Cause | Remedy |
|
|
Sound is not produced. | ÷The speaker cords are disconnected. | ÷Connect properly referring to “System con- | 6 |
|
|
| nection”. | ) |
|
| ÷The volume control is set to the minimum | ÷Adjust to an required volume. |
| |
| position. |
| ¡ |
|
| ÷The MUTE switch of remote control unit is | ÷Switch MUTE OFF. |
| |
| switched ON. |
| ¡ |
|
| ÷The headphone plug is inserted into the | ÷Unplug the headphone plug. |
| |
| jack. |
| 6 |
|
| ÷Connection cords of the system are discon- | ÷Check the connection cords. |
| |
| nected. |
|
|
|
|
|
|
|
|
“PROTECT” is displayed and sound is not | ÷The speaker cords are | ÷Turn the power OFF, remove the short- |
|
|
produced. |
| circuit and turn the power ON again. |
|
|
|
|
|
|
|
No sound from headphones. | ÷The headphones are plugged incompletely. | ÷Plug headphones securely into the jack. | ¡ |
|
|
|
|
|
|
Sound is not produced from the left or | ÷The speaker cords are disconnected. | ÷Connect properly referring to “System con- | 6 |
|
right speakers. |
| nection”. | œ | |
| ÷The balance is set to the left or right extrem- | ÷Adjust the left/right balance. | ||
| ity. |
|
|
|
|
|
|
|
|
| CD player unit |
|
|
|
|
|
|
|
|
|
Symptom | Cause | Remedy |
|
|
A CD is placed in the player but it cannot | ÷The disc is placed upside down. | ÷Place the disc properly, with the label side | ™ |
|
be played. |
| facing upward. |
|
|
| ÷The disc position is displaced. | ÷Place the disc properly. | 5 |
|
| ÷The disc is extremely dirty. | ÷Clean the disc referring to “Disc handling |
| |
|
| precautions”. |
|
|
| ÷The disc is scratched. | ÷Try another disc. | Ø |
|
| ÷Dew is condensed on the optics lens. | ÷Refer to “Beware of condensation” and |
| |
|
| remove the condensation by evaporation. |
|
|
|
|
|
|
|
Sound is not produced. | ÷The disc has not been placed. | ÷Place a disc in the CD player. | ™ |
|
| ÷The player is not put to the play mode. | ÷Press the play(6) key. | 5 |
|
| ÷The disc is extremely dirty. | ÷Clean the disc referring to “Disc handling |
| |
|
| precautions”. |
|
|
| ÷The disc is scratched. | ÷Try another disc. |
|
|
|
|
|
|
|
Sound skips. | ÷The disc is dirty. | ÷Clean the disc referring to “Disc handling | 5 |
|
|
| precautions”. |
|
|
| ÷The disc is scratched. | ÷Try another disc. |
|
|
| ÷The player is subject to vibration. | ÷Install the unit in a place not subject to |
|
|
|
| vibrations. |
|
|
|
|
|
|
|
The tray cannot be closed but opens when | ÷You attempt to close the tray while the | ÷Place the disc correctly along the groove on | ™ |
|
the OPEN/CLOSE key is pressed to close | loaded 8 cm (CD single) disc is deviated | the tray, press the OPEN/CLOSE key, en- | ¢ |
|
an open tray. | from the groove on the tray. | sure that the DISC indicator is lit, and press |
|
|
|
| the play (6) key to start playback. |
|
|
|
|
|
|
|
| Remote control unit |
|
|
|
|
|
|
|
|
|
Symptom | Cause | Remedy |
|
|
Remote control operation is not possible. | ÷Batteries are exhausted. | ÷Replace with new batteries. | ( |
|
| ÷The remote control is too far away from the | ÷Operate the unit inside the remote control- | ( |
|
| system, the controlling angle is deviated or | lable range. |
|
|
| there is an obstacle in between. |
|
|
|
| ÷There is no tape or CD set in the component | ÷Set a tape or CD in the component to be |
|
|
| to be played. | played. |
|
|
| ÷An attempt is made to play the cassette | ÷Wait until the recording ends. |
|
|
| deck which is recording something. |
|
|
|
|
|
|
|
|
| 1. With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape protection function, and not |
Notes | a malfunction. |
2. Do not use longer tape than 110 minutes tapes, for the tape is too thin and gets easily tangled. |