11.Your Brewer will display ‘NOT READY’ as it heats water for the next brew cycle. The ‘READY TO BREW’ indication will return to the LCD Control Center in about
NOTE: Following the brew, your Brewer will fill in preparation for the next brew. The pump will make a vibrating sound. This is normal.
Reservoir, then lifting the Water Reservoir straight up and toward front of Brewer. Fill with water. Place the Water Reservoir back on the Brewer and replace the Lid.
IMPORTANT: Do not remove the Water Reservoir during the brewing process.
Stopping the Brew Process
If you need to stop the brewing after the process has started, press and release the Power Switch to turn the Brewer ‘OFF’. The flow of coffee, tea or hot cocoa will stop, the heating element will shut off and the blue lights illuminating the LCD Control Center and Water Reservoir will disappear.
NOTE: You may get less coffee, tea or hot cocoa in your cup during your next brew. We recommend that you perform a cleansing brew with water only after a terminated brew. Then your NEXT brew will be the volume you have selected.
Adding Water
The LCD Control Center of your Brewer will indicate when the water level in the tank is low or if the Water Reservoir has been removed by displaying the words ‘ADD WATER’. The Brewer will not allow you to initiate a brew when ‘ADD WATER’ is displayed.
The Water Reservoir can be filled in two ways.
1.Lift off the Water Reservoir Lid and pour water directly into the Water Reservoir while it is still attached to the Brewer, then replace the Lid.
2.Remove the Water Reservoir from Brewer by first removing Lid from the Water
Brewing Hot Water
Your Brewer is able to produce a cup of hot water for making hot chocolate in a packet, for use in cooking, for making soups, etc. Simply follow the instructions on page 7 - “Ready To Brew Your First Cup” without adding a
NOTE: After brewing a hot cocoa
Purging the Brewer
If your Brewer has not been used for more than one week, you should purge the water from the inner tank.
1.If there is water in the Water Reservoir, remove the Lid, then lift the Water Reservoir straight up and toward front of the Brewer. Discard water, rinse and refill with bottled or filtered water. Place the Water Reservoir back on the Brewer and replace the Lid. (If there is no water in the Water Reservoir, simply refill.)
2.Be sure the Brewer is turned on. Raise and lower the handle on the Brewer without inserting a
3.The LCD Control Center will display ‘READY TO BREW’ and the ‘LEFT’, ‘RIGHT’ and ‘BREW’ Buttons will flash. Be sure to have a 12 oz. mug on the Drip Tray and then select the Travel Mug size brew.
4.Repeat steps 2 and 3 two more times to completely purge water from inner tank.
If you are experiencing any problems with your Brewer, please contact Customer Service at
8
