Keurig SS-700BK manual Troubleshooting, Problem, Solution

Troubleshooting

Problem:

Solution:

Brewer does not have	Plug Brewer into an independent outlet.
power.
	Make sure the Brewer is securely plugged in.
	Plug into a different outlet.
	Reset your home’s circuit breaker.
	Confirm the power has been turned on and the LCD is illuminated.
Brewer will not brew.	Every once in a while an air bubble may get trapped in the water path. Lift off the
	reservoir, then put it back into place.
	Turn off and unplug the brewer for 30 seconds or more. When you plug the brewer
	back in, be sure to turn the power back on.
	Make sure the water reservoir is properly in place, and perform a Rinse cycle.
	After placing the K-Cup® in the K-Cup® Holder, make sure the handle is pushed
	down securely and the LCD control panel reads READY. The and buttons,
	Brew, Hot Water, and Rinse buttons will be illuminated. Then press any of the lit
	buttons.
	If the LCD control panel indicates ADD WATER, check to make sure the water
	reservoir is properly filled. If not, add water. If so, make sure the water reservoir is
	properly seated in its base.
	If the LCD control panel indicates ADD WATER even after refilling and checking the
	base, contact Customer Service at 1-800-726-0190.
	The exit needle may be clogged (refer to page 19).
Chlorine or mineral	Consider using bottled water, filtered water or the Cuisinart Charcoal Water Filter.
taste in coffee.
Doesn’t brew a full cup.	Every once in a while an air bubble may get trapped in the water path. Lift off the
	reservoir, then put it back into place.
	Turn off and unplug the brewer for 30 seconds or more. When you plug the brewer
	back in, be sure to turn the power back on.
	The exit needle may be clogged (refer to “Cleaning & Maintenance” page 18).
	Clean the K-Cup® holder brewing chamber (refer to “Cleaning & Maintenance”
	page 18).
	Make sure the water reservoir is properly in place, and perform a Rinse cycle.
	De-scale the Brewer (refer to page 20).
	If you have repeated the de-scale procedure two times and it is still only brewing a
	partial cup, contact Customer Service at 1-800-726-0190.
The time is not	You must set the clock (refer to page 15) in order for the time to be displayed on
displayed on the LCD	the LCD.
control panel.
	If power is interrupted to the Brewer, you will need to re-set the clock (refer to
	page 15).
Brewer shuts off, or	Make sure the Auto Off and the On/Off time features have not been set. To do this,
turns on, automatically.	press the Menu button and scroll through the programming options. OFF should be
	displayed for Auto Off timer and On/Off. If OFF is not displayed, you must reset
	(refer to page 15).
The blue light in the	This indicates the water level in the reservoir is low and water must be added (refer
water reservoir is	to page 14) in order to brew a full cup.
flashing.
Coffee is too weak or	Reduce the brew size for a stronger-tasting cup of coffee (refer to “Programming
watery.	Your Brew Size” on page 18). Try an Extra Bold K-Cup®. It has 30% more ground
	coffee in each portion pack.

21