Keys Fitness 7.3t owner manual IMPORTANT, Please Note

Assembly

4.Install the Left and Right Uprights to the tread- mill base frame by inserting the upright connect- ing bracket into base frame as seen in Figure 3, using Allen Bolt 5/16”-18 x 70 (Qty. 4), Spring Washer 8 mm (Qty. 4), and Washer 9*16*1.6 mm (Qty. 4).

Next, install the Allen Bolt 5/16”-18 x 15 (Qty. 6), Spring Washer 8 mm (Qty. 6), and Washer 9*16*1.6 mm (Qty. 6). Refer to Figure 3.

Note: Do not tighten hardware in step 3 until step 5 is completed.

IMPORTANT, PLEASE NOTE:

While sliding the upright connecting bracket into the base frame, make sure the harness is installed inside the upright and pay attention not to pinch the wire harness. Excess Console Harness wiring should be placed inside the Left Upright.

5.Connect the Console Harness together as shown in Figure 4A.

Note: The upright console harness wire should be inserted through grommet in left upright before connecting to harness from console assembly.

6.Connect the Console to the Left and Right Uprights by sliding the Console connecting brack- ets into the end of the Left and Right Uprights as shown in Figure 4. Tighten into place using 5/16”- 18x45 Shoulder Allen Bolt (Qty. 2), Spring Washer 8 mm (Qty. 2), and Washer 9*16*1.6 mm (Qty. 2).

IMPORTANT, PLEASE NOTE:

While connecting the Console to the Left and Right Uprights pay attention not to pinch the wire harness.

LEFT UPRIGHT	RIGHT UPRIGHT
	WASHER 9*16*1.6 mm
	SPRING WASHER 8 mm
	ALLEN BOLT
	5/16”- 18x70
ALLEN BOLT	WASHER 9*16*1.6 mm
	SPRING WASHER 8 mm
5/16”-18x15

Figure 3: Left and Right Upright Installation

CONSOLE
	EKG HARNESS
CONSOLE	SHOULDER ALLEN
HARNESS
	BOLT 5/16”-18x45
	SPRING WASHER 8 mm
LEFT UPRIGHT	WASHER 9*16*1.6 mm
	RIGHT UPRIGHT

Figure 4: Console Installation

LEFT UPRIGHT

CONSOLE HARNESS

GROMMET

Figure 4A: Wiring Harness Installation

7