Safety Precautions and Tips
It is the owner's responsibility to ensure that all users of this exercise bike have read the Owner's Manual and are familiar with warnings and safety precautions.
•This exercise bike has a maximum user capacity of 300 pounds.
•The AirBike should only be used on a level surface and is intended for indoor use only. It should not be placed in a garage, patio or near water. Keys Fitness recommends an equipment mat be placed under the bicycle to protect the floor or carpet and for easier cleaning.
•Wear comfortable,
•Always examine your exercise bike before using to ensure all parts are in working order.
•Do not leave children unsupervised near or on the exercise bicycle.
•Never operate the exercise bicycle where oxygen is being administered or where aerosol products are being used.
•Never insert any object or body parts into any opening.
•Service to your AirBike should only be performed by an authorized service representative, unless authorized and/or instructed by a Keys Fitness technician. Failure to follow these instructions will void the warranty.
2
Assembly of the AirBike
REMOVE ALL SECURITY TAPE AND WRAPPING BEFORE BEGINNING.
1.Attach front stabilizer bar (16) and rear stabilizer bar (3) to the frame by using the bolts (17), washers (12, 13) and cap nuts (15) provided. Please note that the center distance between the two screw holes of the front stabilzer bar is longer than the center distance between the two screw holes of the front stablizer bar is longer than the center distance between the two screw holes of the rear stabilizer bar.
2.Attach pedals (14). Axles of pedals are branded "L" and "R". The pedal marked "R" goes on the right hand side of the bike and the one marked "L" on the left hand side. Tighten each pedal by turning bolt towards the front of the bike. (Tighten the left pedal bolt
3.Mount the saddle (No.1) to the seat post (2). Level the saddle then fasten the nuts and both sides of the saddle.
4.Adjust the height of the seat post according to your require- ments by using the quick release seat knob (4)
5.Using the cord provided, tie to the computer cable (9) and pull up throught the head stem (10) then untie the cord. Connect the computer cable in the console tube to the computer cable in the main frame.
6.Insert the head stem onto the frame. Secure in position with bolts (11) and washers (12, 13) provided.
3
