7.With PIVOT TUBES on rear side of HANDLEBARS and CONNECTING ARMS to inside, slide RIGHT and LEFT HANDLEBARS onto AXLE. Slide LARGE WASHER onto end of AXLE. Carefully tap PUSHNUT onto end of AXLE with hammer. Connect heart rate wires from CONSOLE TUBE (B) to heart rate wire in each handlebar (A).
8.ATTACHING CONNECTING ARMS TO PEDALS: (DUAL ACTION MODE)
Slide RETAINER onto CONNECTING ARM until it has cleared SLOT in CONNECTING ARM as shown in DETAIL.
DETAIL
Lower SLOT in CONNECTING
ARM down over PEDAL
BUSHING - see Figure A.
Slide RETAINER in direction of
ARROW until CONNECTING
ARM is locked in DUAL
ACTION MODE - see Figure B.
FIGURE A
FIGURE B
10 | 11 |
