Kicker CX.1-SERIESAMPLIFIERS OWNER’S MANUAL, Model, CX300.1 / CX600.1 / CX1200.1, Performance

CX.1-SERIES AMPLIFIERS

OWNER’S MANUAL

MODEL:	CX300.1 / CX600.1 / CX1200.1
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
PERFORMANCE
Model:	CX300.1	CX600.1	CX1200.1
RMS Power
@ 14.4V, 4Ω mono, ≤ 1% THD+N	150W x 1	300W x 1	600W x 1
@ 14.4V, 2Ω mono, ≤ 1% THD+N	300W x 1	600W x 1	1200W x 1
Length in [mm]	8-1/8 [210]	8-1/8 [210]	12-1/16 [310]
Specifications common to all models:
Height in [mm]	2-3/8 [60]
Width in [mm]	7-3/16 [180]
Frequency Response ± 1dB	25Hz–200Hz
Signal-to-noise Ratio	>95dB, A-weighted, re: rated power
Input Sensitivity	Low Level: 125mV–5V
	High Level: 250mV–10V
Electronic Crossover	Variable Lo-pass 50Hz–200Hz, 12dB/octave
Bass Boost	Variable 0–12dB @ 40Hz
Subsonic Filter	25Hz, 24dB/octave
Remote Bass	Yes [sold separately]

Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use genuine KICKER accessories and wiring.

INSTALLATION

Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm) of open ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill four holes using a 7/64” (3mm) bit and use the supplied #8 screws to mount the amplifi er.

The KICKER CX Amplifi ers are capable of space-saving vertical mounting. Use a 2.5mm hex key (Allen wrench) to loosen the endpanel, remove the existing brackets, then insert and tighten the double-slotted brackets to the amplifi er as illustrated on the next page.

2

2012 CX Mono Amps Rev I.indd 2

6/22/2012 2:32:28 PM