66 | 4 Configuring the system |
Installing or Removing a DVD/CD-RW or CD-ROM Drive
CAUTION: DVD/CD-RW and CD-ROM drives are NOT hot swappable. Before removing or replacing the drive, you must first take the server out of service, turn off all peripheral devices connected to the system, turn off the system by pressing the power button, and unplug the AC power cord from the
system or wall outlet.
Installing a DVD/CD-RW or CD-ROM Drive into Slimline Bay (Backplane Installed)
NOTE: The carrier for the slimline DVD/CD-RW drive / CD-ROM drive was pre-installed in the slimline drive bay of your Altos R510 Server Chassis.
1Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”
2Power down the server and unplug all peripheral devices and the AC power cable.
3Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
4Remove the front bezel if it is installed. For instructions, see “Removing and Installing the Front Bezel.”
5Push in on the blue lever at the rear of the DVD/CD-RW or CD-ROM drive carrier and push the carrier out through the front of the chassis.
6Align the two holes at left edge of DVD/CD-RW or CD-ROM drive with the cutouts in drive carrier. See letter “A” in the figure below.
7Lower the right side of the DVD/CD-RW or CD-ROM drive into the carrier until it clicks into place. See letter “B” in the figure below.
