50 | 4 Configuring the system |
8Align the holes in the drive to the holes in the drive carrier and attach it to the carrier with the screws that were attached to the plastic retention device.
9With the black lever in the fully open position, slide the drive assembly into the chassis. The green latch at the front of the drive carrier must be to the right. Do not push on the black drive carrier lever until the lever begins to close by itself.
10When the black drive carrier lever begins to close by itself, push on it to lock the drive assembly into place.
11(Optional) Install the front bezel.
A
B
Removing a SATA or SCSI Hot-swap Hard Disk Drive
Use these instructions only if you have installed the SATA or SCSI backplane kit.
