73

6Line up the screws on the riser assembly with the slot and the large hole on the riser connector.

7Press and hold the blue riser locking lever. See letter “A” in the figure below.

8Place riser connector onto the retention pins.

9Slide the riser connector to the right to lock it into place.

10Release the blue locking lever.

11Install a PCI add-in card, if desired. For instructions, see “Installing a PCI Add-in Card.”

12Position the riser assembly over the PCI sockets on the server board (see letter “A” in the figure below), lining up the four hooks at the rear of the riser assembly (see letter “B”) with the four slots in the rear of the chassis (see letter “C”).

13Push the riser assembly down until the assembly is securely seated.

Page 85
Image 85
Acer Altos R510 manual