45 |
A |
B |
E |
D |
C |
A |
15See letter “B” in the figure below and the arrow that leads from this letter to the component in the chassis. This component is the air baffle that is referred to in the following steps. The letter “B” points to the cutout that is referred to.
16Power cables for drives installed to the right side of the air baffle must be routed beneath the front cutout in the underside of the air baffle. The power cable for a drive installed to the left of the air baffle does not need to be routed under the air baffle. See letter “B” in the figure below to identify the air baffle and the cutout area. You may need to remove the air baffle to route cables underneath it. To see how to remove and then install the air baffle, see “Removing and Installing the Air Baffle. “
17Connect the SATA power cable adapter end(s) to the rear of the SATA drive. See letter “A” in the figure below to locate the connector on the SATA drive.
