Acer Altos R510 Power Light Does Not Light, No Characters Appear on Screen, Check the following

148 6 Troubleshooting

•System cooling fans do not rotate.

•Diskette drive activity light does not light.

•Hard disk drive activity light does not light.

•CD-ROM drive activity light does not light.

•There are problems with application software.

•The bootable CD-ROM is not detected.

Try the solutions below in the order given. If you cannot correct the problem, contact your service representative or authorized dealer for help.

Power Light Does Not Light

Check the following:

•Did you press the power-on button?

•Is the system operating normally? If so, the power LED might be defective or the cable from the control panel to the server board might be loose.

•Have you securely plugged the server AC power cord into the power supply?

•Some ATX power supplies have a power switch on the back of the power supply, next to the fan. If your system has one, is it turned on?

•Remove all add-in cards and see if the system boots. If successful, add the cards back in one at a time with a reboot between each addition.

•Make sure the memory DIMMs comply with the system requirements.

•Make sure the memory DIMMs have been populated according to the system requirements.

•Remove the memory DIMMs and re-seat them.

•Make sure the processor(s) comply with the system requirements.

•Make sure the processor(s) have been populated according to the system requirements.

•Remove the processor(s) and re-seat them.

•Make sure the chassis standoffs are installed only below mounting holes. Misplaced standoffs can contact the pins on the bottom of the server board and cause a short.

No Characters Appear on Screen

Check the following:

•Is the keyboard functioning? Test it by turning the “Num Lock” function on and off to make sure the Num Lock light is functioning.

•Is the video monitor plugged in and turned on? If you are using a switch