Acer Altos R510 manual

69

8Disconnect the data cable from the rear of the DVD/CD-RW or CD- ROM drive.

9Remove the two screws at the rear of the DVD/CD-RW or CD-ROM drive to disconnect the interposer board.

10Store the screw and interposer board for future use. Suggestion: tape the screw to the drive carrier.

11Slide the empty drive carrier into the chassis until it clicks into place.

12Install the chassis cover. For instructions, see “Installing the Chassis Cover.”

13(Optional) Install the front bezel. For instructions, see “Removing and Installing the Front Bezel.”

14Plug all peripheral devices and the AC power cable back into the server.

Installing DVD/CD-RW or CD-ROM Drive into Slimline Bay (No Backplane Installed)

NOTE: The carrier for the slimline DVD/CD-RW drive / CD-ROM drive was pre-installed in the slimline drive bay of your Altos R510 Server Chassis. The interposer board and floppy drive power adapter cable used in these instructions was sent to you with your fixed drive kit.

1Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”

2Power down the server and unplug all peripheral devices and the AC power cable.

3Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”

4Remove the front bezel if it is installed. For instructions, see “Removing and Installing the Front Bezel.”

5Push in on the blue lever at the rear of the DVD/CD-RW or CD-ROM drive carrier and push the carrier out through the front of the chassis.