54 | 4 Configuring the system |
10Slide the floppy drive assembly into the slimeline bay of the chassis until it clicks into place. See letter “A” in the figure below.
11Open the connector labeled “Floppy Con” on the backplane by pulling up on the connector cover. See letter “B” in the figure below.
12Insert the loose end of the floppy cable into the backplane connector. See letter “C” in the figure below.
13Push in on the connector cover to lock the cable into place. See letter “D” in the figure below.
14Install the chassis cover. For instructions, see “Installing the Chassis Cover.”
15(Optional) Install the front bezel. For instructions, see “Removing and Installing the Front Bezel.”
16Plug all peripheral devices and the AC power cable back into the server.
