Acer Altos R510 manual

61

Installing a Floppy Drive into the Converted Hard Drive Bay (Backplane Installed)

The slimline floppy drive conversion kit can only be installed into a system that is using either the SATA or the SCSI backplane. You will know if you have one of these backplanes installed if you can install either hot-swap SATA or hot-swap SCSI drives. The conversion kit must be installed in the left hard drive bay.

1Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”

2Power down the server and unplug all peripheral devices and the AC power cable.

3Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”

4Remove the front bezel if it is installed. For instructions, see “Removing and Installing the Front Bezel.”

5Remove the left hot-swap hard drive carrier from the chassis.

6Remove the screws that attach the slide rails to the floppy drive conversion kit carrier.

7Slide the floppy drive into the drive carrier, rear of the drive first, with the underside of the drive facing down.

8Line up the holes in the side of the drive with the holes in the carrier. See letter “A” in the figure below.