48 | 4 Configuring the system |
Installing a SATA or SCSI Hot-swap Hard Disk Drive
Use these instructions only if you have installed the SATA or SCSI backplane kit. Please refer to Page 79 for details of how to install the backplane.
1Remove the front bezel if it is installed. For instructions, see “Removing and Installing the Front Bezel.”
2Press in on the green latch at the front of the hard drive carrier. See letter “A” in the figure below.
3Pull out on the black lever and slide the carrier from the chassis. See letter “B” in the figure below.
B
A
4Remove the four screws that attach the plastic retention device or the previously installed hard drive to the drive carrier. Two screws are at each side of the retention device or the hard drive. Store the plastic retention device for future use.
