44 | 4 Configuring the system |
11For each drive you install, route one SATA data cable from the server board or
12See letters “C”, “D”, and “E” in the figure below and the arrow that leads from them to the component in the chassis. This component is the air baffle that is referred to in the following steps. The letters “C” and “D” point to the cutouts that are referred to in the step below. The letter “E” is the tab at the top of the air baffle.
13Data cables for drives installed to the right of the air baffle must be routed through the two cutouts in the top of the air baffle (letters “C” and “D” in the figure) and under the tab (letter “E”). The data cable for a drive installed to the left of the air baffle must be routed through the rear cutout of the air baffle (letter “D”) and under the tab (letter “E”). You may need to remove the air baffle to route the cables underneath it. To see how to remove and then install the air baffle, see “Removing and Installing the Air Baffle. “
14Connect the loose end of the data cable to the rear of the SATA drive. See letter “A” in the figure to identify the location of the connector at the rear of the SATA drive.