Acer Altos R510 manual

65

5Open the connector labeled “Floppy Con” on the backplane by pulling up on the connector cover. Remove the flat flex cable from the backplane.

6Push in on the lever at the rear of the floppy carrier and slide the drive from the front of the chassis.

7Open the connector cover on the rear of the floppy drive by pulling up on it. Release the flat flex cable from the drive.

8Remove the two screws at each side that hold the drive rails to the drive carrier. Lift the two rails from the carrier.

9Disconnect the two screws attaching the drive to the converted hard drive bay carrier.

10Install an empty hot-swap hard drive carrier into chassis drive bay if no floppy or hard drive is to be installed into the bay.

11Store the screws, the converted drive bay carrier, the side rails, and the flat flex cable for future use.

12Install the chassis cover. For instructions, see

13(Optional) Install the front bezel.

14Plug all peripheral devices and the AC power cable back into the server.