47
1Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”
2Power down the server and unplug all peripheral devices and the AC power cable.
3Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
4Remove the front bezel if it is installed. For instructions, see “Removing and Installing the Front Bezel.”
5Disconnect the SATA data connector and power cables from the rear of the SATA drive.
6Press the latch on the back of the fixed drive carrier and slide it out of the bay.
7Remove the four screws that attach the hard drive to the drive carrier. Lift the drive from the carrier. Store the drive in an anti- static bag.
8If you are not installing a new drive, place the plastic retention device into the drive carrier, using the four screws you removed from the hard drive.
9Insert the screws that held the drive in the carrier into the screw locations on the carrier for future use.
10Slide the drive carrier back into the chassis until it clicks into place.
NOTE:For proper airflow, the hard drive carrier must be replaced in the chassis, even if no hard drive is installed in it.
11(Optional) Install the front bezel. For instructions, see “Removing and Installing the Front Bezel.”
12Install the chassis cover. For instructions, see “Removing the Chassis Cover.”
13Plug all peripheral devices and the AC power cable back into the server.
