58

A

4 Configuring the system

B

15Slide the floppy drive assembly into the chassis until it clicks into place. See letter “A” in the figure below.

16Connect the 2x2 end of the floppy drive power cable that was included with your kit to the 2x2 power connector on the SATA power adapter cable. See letters “B” and “C” in the figure below.

17Connect the remaining end of the floppy drive power cable to the power connector on the rear of the floppy drive. See letter “D” in the figure.

18Connect the floppy drive data cable that was included with your kit between the floppy drive data connector and the server board. See letters “E” and “F” in the figure. See your server board documentation for assistance in locating the connector location on the server board.

19Route the floppy drive data cable over the air baffle, as shown in the diagram below.

Page 70
Image 70
Acer Altos R510 manual Configuring the system