HP 625n Gigabit Ethernet Print Server manual Configuration Parameters 4, TCP/IP Settings 1

Table 4.3	802.11 Configuration Parameters (4 of 4)
Item		Description
TCP/IP settings		To minimize reconnections to the print server for initial network
		configuration, the 802.11 page allows you to configure the
		following basic TCP/IP settings at the same time that you
		configure your wireless connection settings:
		●	IP Configuration Method
		●	IP address
		●	Subnet Mask
		●	Default Gateway
		For a description of these parameters, see TCP/IP below.

TCP/IP

The TCP/IP page provides configuration parameters summarized in Table 4.4.

Table 4.4	TCP/IP Settings (1 of 3)
Item		Description
IP Configuration		Selects the method that the HP Jetdirect print server will use for
Method		its IP configuration parameters: BOOTP (default), DHCP,
		Manual, or Auto IP.
		For BOOTP or DHCP, the IP parameters will be automatically
		configured by a BOOTP or DHCP server each time the print
		server is powered on.
		If you select Manual, then basic IP parameters can be manually
		entered using this Web page, or using other available tools.
		If you select Auto IP, then a unique link-local address 169.254.x.x
		will be assigned.
		For more information, see Chapter 3.
Host Name		Specifies a readable IP name (the SNMP SysName object) for
		the network device. The name must start with a letter and can
		end in a letter or number, up to 32 ASCII characters. The default
		name is NPIxxxxxx, where xxxxxx is the last six digits of the LAN
		hardware (MAC) address.
IP Address		Use this field to manually assign the Internet Protocol address on
		the HP Jetdirect print server. The IP address is a four byte (32-bit)
		address in the form "n.n.n.n", where 'n' is a number from 0 to 255.
		An IP address uniquely identifies a node on a TCP/IP network.
		Duplicate IP addresses on a TCP/IP network are not allowed. For
		more information on IP addresses, see Appendix A.

ENWW Using the Embedded Web Server 115