HP 625n Gigabit Ethernet Print Server manual Telnet Commands and Parameters 13

Table 3.4 Telnet Commands and Parameters (13 of 18)

set-cmnty-name	Specifies a password that determines which SNMP
	SetRequests (control functions) the HP Jetdirect print server
	will respond to. The community name of an incoming SNMP
	SetRequest must match the print server’s “set community
	name” for the print server to respond. (For additional
	security, you may limit configuration access through the print
	server’s host access list.) Community names must be ASCII
	characters. The maximum length is 255 characters.
default-get-cmnty	Enables or disables the default Get community name.
	0 disables, 1 (default) enables.
	Disabling this parameter may prohibit communications with
	SNMP management applications.
SNMP Traps
Command	Description
auth-trap	Configures the print server to send (on) or not send (off)
	SNMP authentication traps. Authentication traps indicate
	that an SNMP request was received, but the community
	name check failed. 0 is off, 1 (default) is on.
trap-dest	Enters a host IP address into the HP Jetdirect print server’s
	SNMP trap destination list. The command format is:
	trap-dest: ip-address[community name] [port number]
	The default community name is ‘public’; the default SNMP
	port number is ‘162’. The port number cannot be specified
	without a community name.
	To delete the table, use ‘trap-dest: 0’.
	If the list is empty, the print server does not send SNMP
	traps. The list may contain up to three entries. The default
	SNMP Trap Destination List is empty. To receive SNMP
	traps, the systems listed on the SNMP trap destination list
	must have a trap daemon to listen to those traps.
IPX/SPX
Command	Description
ipx-config	Enables or disables IPX/SPX protocol operation on the print
	server. 0 disables, 1 (default) enables. For example,
	ipx-config 0 will disable IPX/SPX operation.
ipx-unitname	(Print Server Name) A user-assigned alphanumeric name
	assigned to the print server (31 characters maximum). By
	default, the name will be NPIxxxxxx, where xxxxxx are the
	last six digits of the LAN hardware address.
Address	(Read-only parameter) Identifies the IPX network and node
	numbers detected on the network, in the form
	NNNNNNNN:hhhhhhhh (hexadecimal), where
	NNNNNNNN is the network number and hhhhhhhh is the
	LAN hardware address of the print server.

ENWW TCP/IP Configuration 91