HP 625n Gigabit Ethernet Print Server manual Error Messages 1, Error Code Description Message

Error Messages

Error codes and messages that may appear in the Status sections of the Jetdirect configuration page are described in Table 9.11.

Table 9.11 Error Messages (1 of 11)

Error Code and	Description
Message
02 LAN ERROR -	During self-test, the HP Jetdirect print server detected an
INTERNAL	internal loopback test error. The print server may be faulty.
LOOPBACK	If the error persists, replace the HP Jetdirect print server.
03 LAN ERROR -	The HP Jetdirect print server is incorrectly connected to
EXTERNAL	your network or is defective. Make sure your HP Jetdirect
LOOPBACK	print server is correctly attached to your network. In addition,
	check the cabling and connectors.
05 NO SIGNAL	(802.11 Wireless, Infrastructure Mode only) The print server
DETECTED	did not find an Access Point and did not detect a radio signal.
	Check for sources of radio signal interference. If possible,
	elevate the print server or the external antenna (if
	applicable). Verify other wireless devices are turned on and
	located in wireless signal range of the print server.
06 ENCRYPTION	Encryption is required on this network, but the print server
REQUIRED	cannot communicate on the network due to improper
	encryption settings. Check the encryption settings
	configured on the print server.
07 LAN ERROR -	Check the network connections. If the connections are
CONTROLLER CHIP	intact, run the power-on self-test: turn the printer off, then
	on again. If the error persists, replace the HP Jetdirect
	print server.
07 AUTHENTICATION	The Jetdirect print server could not access the network
FAILED	because of an authentication error. The error depends on
	the authentication method used.
	Verify the authentication method and settings on the print
	server.
08 LAN ERROR -	There is a network congestion problem.
INFINITE DEFERRAL	Note: If the print server is not connected to the network, this
	error cannot occur.
08 AUTHENTICATION	Link-level authentication is in progress.
IN PROGRESS
09 LAN ERROR -	Check the network connections. If the connections are
BABBLE	intact, run the power-on self-test: turn the printer off, then
	on again. If the error persists, replace the HP Jetdirect print
	server. For replacement instructions, see the hardware
	installation guide for your print server.

ENWW HP Jetdirect Configuration Page 225