Table 3.4 Telnet Commands and Parameters (15 of 18)
Status | |
| configuration status. |
| READY: Indicates the HP Jetdirect print server is awaiting |
| data. |
| DISABLED: Indicates that AppleTalk was manually |
| disabled. |
| INITIALIZING: Indicates that the print server is registering |
| the node address or name. An additional status message |
| may also be displayed. |
|
|
DLC/LLC |
|
Command | Description |
|
|
Enables or disables DLC/LLC protocol operation on the print | |
| server. 0 disables, 1 (default) enables. For example, |
| |
|
|
Controls DLC/LLC protocol interpretation: | |
| 0 (default): disables, that is, provides loose interpretation. |
| 1: enables, that is, provides strict interpretation). |
|
|
Other |
|
Command | Description |
|
|
upgrade | To configure one or more Jetdirect print servers with the |
| name and location of a firmware upgrade file. |
| CAUTION: Ensure that command parameters are properly |
| entered and that the upgrade file is a higher version than the |
| currently installed version. The print server will attempt to |
| upgrade when the upgrade file contains a higher version |
| than the installed version. |
| The command format is: |
| upgrade: <TFTP server IP> <Version> <Product Number> |
| <Filename> |
| where, |
| <TFTP Server IP> is the IP address of the TFTP server, |
| <Version> specifies the firmware version of the upgrade file, |
| <Product Number> specifies and must match the product |
| number of the print server, |
| <Filename> is the path and filename of the firmware |
| upgrade file. |
|
|
laa | Specifies a locally administered address (LAA) that replaces |
| the |
| is used, a |
| digits must be entered. |
| For Ethernet print servers, the LAA address must start with |
| hexadecimal X2, X6, XA, or XE, where X is any hexadecimal |
| digit 0 through F. |
| The default address is the |
|
|
ENWW | TCP/IP Configuration 93 |
