Troubleshooting Wireless Print Servers
Unable to Communicate During Initial Setup
If you are using wireless communications to set up the print server, verify the following:
●Your wireless computer is configured to match the default wireless network settings on the HP Jetdirect print server:
■Communication Mode: Ad Hoc
■Network Name (SSID): hpsetup
■Encryption (WEP): <Disabled>
Note | The Network Name (SSID) is |
| sure to specify “hpsetup” using lowercase |
| characters. |
|
|
●The HP Jetdirect print server is turned on and operating properly (print a Jetdirect configuration page).
●You are within range of the HP Jetdirect print server.
●There are fewer than six devices total on the Ad Hoc network (with SSID “hpsetup”).
●There is no Access Point in the vicinity that is configured with an SSID of “hpsetup”.
●Multiple print servers are not being configured at the same time. If there are multiple print servers, turn all off except the one you want to configure.
ENWW | Troubleshooting the HP Jetdirect Print Server 196 |
