HP 625n Gigabit Ethernet Print Server manual Error Messages 2

Table 9.11 Error Messages (2 of 11)

Error Code and	Description
Message
09 SCANNING FOR	(802.11 Wireless) The print server is scanning on all
SSID	channels for devices on the specified SSID (network name).
	Check your specified SSID, or check status of the Access
	Point (Infrastructure mode) or other wireless devices.
	The print server will continue to scan for the specified SSID.
0A LAN ERROR -	(Wired Ethernet) Check the network connections. If the
NO SQE	connections are intact, run the power-on self-test: turn the
	printer off, then on again. If the error persists, replace the
	HP Jetdirect print server.
0C LAN ERROR -	There may be a problem with your network cabling or the
RECEIVER OFF	HP Jetdirect print server. Check the cabling and connectors
	on your Ethernet network. If you cannot find a problem with
	your network cabling, run the power-on self-test: turn the
	printer off, then on again. If the error persists after the printer
	is turned on again, there is a problem with the HP Jetdirect
	print server.
0D LAN ERROR -	There may be a problem with your network cabling or the
TRANSMITTER OFF	HP Jetdirect print server. Check the cabling and connectors
	on your Ethernet network. If you cannot find a problem with
	your network cabling, run the power-on self-test: turn the
	printer off, then on again. If the error persists, there is a
	problem with the HP Jetdirect print server.
0E LAN ERROR -	Check the network connections. If the connections are
LOSS OF CARRIER	intact, run the power-on self-test: turn the printer off, then
	on again. If the error persists, replace the HP Jetdirect
	print server.
10 LAN ERROR -	(Wired Ethernet) There may be a problem with your network
UNDERFLOW	cabling or the HP Jetdirect print server. Check the cabling
	and connectors on your network. If you cannot find a
	problem with your network cabling, run the power-on
	self-test: turn the printer off, then on again. If the error
	persists, there is a problem with the HP Jetdirect print
	server.
11 LAN ERROR -	(Wired Ethernet) There is a problem with your network
RETRY FAULTS	cabling or external network configuration. Verify operation
	of the hub or switch port.
12 LAN ERROR -	With a 10/100 Base-TX port connected, this message is
NO LINKBEAT	displayed if Link Beat is not sensed. Check the network
	cable, and verify that the concentrator/hub is providing Link
	Beat.
13 NETWORK	Reset or power off/on the HP Jetdirect print server to enable
RECONFIG - MUST	new configuration values.
REBOOT

ENWW HP Jetdirect Configuration Page 226