Table 9.6 | TCP/IP Configuration Information (2 of 4) | ||
|
|
| |
Message |
| Description | |
|
| ||
DEFAULT GATEWAY: | The IP address of the gateway used when sending packets | ||
|
| off the local network. Only one default gateway may be | |
|
| configured. During initialization, a temporary value 0.0.0.0 | |
|
| is displayed. If not provided, the IP address of the Jetdirect | |
|
| print server is used. | |
|
| NOT SPECIFIED: Indicates that a default gateway is not | |
|
| configured. | |
|
|
| |
CONFIG BY: |
| Identifies how the HP Jetdirect print server obtained its | |
|
| IP configuration: | |
|
| BOOTP: Automatic configuration through a BOOTP server. | |
|
| BOOTP/TFTP: Automaticautomatic configuration through | |
|
| a BOOTP server and TFTP configuration file. | |
|
| DHCP: Automatic configuration through a DHCP server | |
|
| DHCP/TFTP: Automatic configuration through a DHCP | |
|
| server and TFTP configuration file. | |
|
| RARP: Automatic configuration through the Reverse | |
|
| Address Resolution Protocol. | |
|
| USER SPECIFIED: Manual configuration through Telnet, | |
|
| the printer’s control panel, HP Web Jetadmin, embedded | |
|
| Web server, or other method. | |
|
| DEFAULT IP: The default IP address was assigned. This | |
|
| address may not be a valid address for your network. | |
|
| AUTO IP: A | |
|
| assigned. If the network is a | |
|
| should be valid. | |
|
| NOT CONFIGURED: The print server was not configured | |
|
| with IP parameters. Verify that TCP/IP is enabled, or check | |
|
| for error status. | |
|
| ||
BOOTP SERVER: | Displayed if BOOTP, DHCP, or RARP is used for TCP/IP | ||
or |
| configuration. It specifies the IP address of the system that | |
DHCP SERVER: | responds to the HP Jetdirect print server's request for | ||
automatic TCP/IP configuration over the network. | |||
or |
| ||
| NOT SPECIFIED: Indicates that the configuration server's | ||
RARP SERVER: | |||
IP address could not be determined or was set to zero in | |||
|
| ||
|
| the response packet. | |
|
| ||
BOOTP/DHCP | Displayed during initialization while the HP Jetdirect print | ||
SERVER: |
| server attempts to obtain its TCP/IP configuration from a | |
|
| BOOTP or DHCP server. The temporary address | |
|
| displayed is 0.0.0.0. | |
|
|
| |
ENWW | HP Jetdirect Configuration Page 216 |
