HP 625n Gigabit Ethernet Print Server manual Tftp Configuration File Parameters 8

Table 3.3 TFTP Configuration File Parameters (8 of 12)

get-cmnty-name:

(get-community-name:)

Specifies a password that determines which SNMP GetRequests the HP Jetdirect print server will respond to. This is optional. If a user-specified get community name is set, the print server will respond to either a user-specified community name or the factory-default. The community name must be ASCII characters. The maximum length is 255 characters.

set-cmnty-name:

(set-community-name:)

Specifies a password that determines which SNMP SetRequests (control functions) the HP Jetdirect print server will respond to. The community name of an incoming SNMP SetRequest must match the print server’s “set community name” for the print server to respond. (For additional security, you may limit configuration access through the print server’s host access list). Community names must be ASCII characters. The maximum length is 255 characters.

auth-trap:

(authentication-trap:)

Configures the print server to send (on) or not send (off) SNMP authentication traps. Authentication traps indicate that an SNMP request was received, but the community name check failed. The default is “on.”

trap-dest:

(trap-destination:)

Enters a host’s IP address into the HP Jetdirect print server’s SNMP trap destination list. The command format is:

trap-dest: ip-address[community name] [port number]

The default community name is ”public”; the default SNMP port number is ”162”. The port number cannot be specified without a community name.

If a ”trap-community-name” command is followed by ”trap-dest” commands, the trap community name will be assigned to those entries unless a different community name is specified in each ”trap-dest” command.

To delete the table, use ”trap-dest: 0”.

If the list is empty, the print server does not send SNMP traps. The list may contain up to three entries. The default SNMP Trap Destination List is empty. To receive SNMP traps, the systems listed on the SNMP trap destination list must have a trap daemon to listen to those traps.

IPX/SPX

ipx-config:

(ipx/spx:)

Enables or disables IPX/SPX protocol operation on the print server: 0 disables, 1 (default) enables.

ENWW TCP/IP Configuration 57