Table 9.1 | HP Jetdirect Configuration (2 of 2) | |
|
|
|
Message |
| Description |
|
| |
PORT SELECT: | (Ethernet only) Specifies the port on the HP Jetdirect print | |
|
| server that has been detected for use: |
|
| NONE: The print server is not connected to the network. |
|
| |
|
|
|
LAA |
| The Locally Administered Address (LAA) identifies the |
|
| |
|
| which may be required by some network administrators. |
|
| The default address is the print server’s |
|
| hardware address. |
|
| |
PORT CONFIG: | Identifies the link configuration of the | |
|
| HP Jetdirect |
|
| |
|
| |
|
| 100TX HALF: 100Mbps, |
|
| |
|
| UNKNOWN: The print server is in an initialization state. |
|
| DISCONNECTED: A network connection has not been |
|
| detected. Check network cables. |
|
| |
AUTONEGOTIATION | Identifies whether IEEE 802.3u Autonegotiation on the | |
|
| HP Jetdirect 10/100TX port is enabled (ON) or disabled |
|
| (OFF). |
|
| ON (default): The HP Jetdirect print server will attempt to |
|
| automatically configure itself onto the network at the proper |
|
| speed (10 or 100 Mbps) and mode (half or full duplex). |
|
| Autonegotiation is enabled after a cold reset. |
|
| OFF: You must manually configure the speed and mode |
|
| using the EIO menu from the printer’s control panel. If |
|
| Autonegotiation is off, the settings must match those of |
|
| the network for proper operation. |
|
| |
MANUFACTURING ID: | The manufacturing identification code for use by HP online | |
|
| support personnel. |
|
|
|
DATE |
| Identifies the date of manufacture of the HP Jetdirect print |
MANUFACTURED: | server. | |
|
|
|
ENWW | HP Jetdirect Configuration Page 206 |