Table 4.8 | Miscellaneous Settings (2 of 5) | |
Item |
| Description |
|
|
|
Link settings |
| (For wired 10/100TX networks only) Set the network link |
|
| speed(10 or 100 Mbps) and communication mode (full- or |
|
| |
|
| available settings are listed below. |
|
| CAUTION: If you change the link setting, network |
|
| communications with the print server and network device may |
|
| be lost. |
|
| ● AUTO: (Default) The print server uses autonegotiation to |
|
| match the network’s link speed and communication mode. If |
|
| autonegotiation fails, 100TXHALF is set. |
|
| ● 10TXFULL: 10 Mbps, |
|
| ● 10TXHALF: 10 Mbps, |
|
| ● 100TXFULL: 100 Mbps, |
|
| ● 100TXHALF: 100 Mbps, |
|
|
|
Network |
| HP Jetdirect ew2400 wired/wireless print servers support a |
Connection |
| network connection using either a wired 802.3 port using a |
|
| network cable, or a wireless 802.11 port. However, only one port |
|
| can be active at a time. For these print servers, you should specify |
|
| the active port behavior. |
|
| ● AUTO (Cable Detect): Automatically detects whether an |
|
| 802.3 network cable is attached. If a network cable is not |
|
| attached, only the 802.11 wireless port will be active. |
|
| However, if a network cable is attached, then only the 802.3 |
|
| wired port will be active. |
|
| ● Disable Wire: Disables the 802.3 wired port, whether or not a |
|
| network cable is attached. Only the 802.11 wireless port will |
|
| be active. |
|
| ● Disable Radio: Disables the 802.11 wireless port. Only the |
|
| 802.3 wired port will be active. |
|
|
|
Primary DNS |
| Specify the IP address of the primary DNS (Domain Name |
Server |
| System) server. |
|
| |
Secondary DNS | Specify the IP address of a secondary DNS server to use if the | |
Server |
| primary DNS server is unavailable. |
|
|
|
Email (SMTP) |
| Specify the IP address of the preferred outgoing |
Server |
| Mail Transport Protocol (SMTP) server, for use with supported |
|
| Scan devices. |
|
|
|
ENWW | Using the Embedded Web Server 124 |
